Table of Contents
Advertisement
Verifying the Switch with AlliedWare Plus Commands
Now that you have installed the switch and powered it on for the first time,
you should verify that the hardware components are operating correctly.
The following procedure show how to do this using commands in the
AlliedWare Plus operating system. To verify the hardware operations of
the switch, perform the following procedure:
1. Start a local management session on the switch. For instructions, refer
to "Starting a Local Management Session" on page 81.
2. To display the status of the power supply, enter the SHOW SYSTEM
ENVIRONMENT command in the User Exec or Privileged Exec mode.
The Status column in the display provides the states of the modules.
Components are operating normally when they have an "Ok" status.
3. To display the states of the ports, use the SHOW INTERFACE
STATUS command in the Privileged Exec mode.
For information about the command line interface, refer to the Software
Reference for AT-x950 Switches on the Allied Telesis web site.
x220 Series Installation Guide
83
Advertisement
Table of Contents
