Table of Contents
Advertisement
Configuring IPMS on a Switch
Configuring an IGMP Static Group
You can configure a port as an IGMP static group by entering
IP address of the static group in dotted decimal notation, a space, followed by vlan, a space, VLAN
number (which must be between 0 and 4095), a space, followed by port, a space, the slot number of the
port, a slash (/), and the port number.
For example, to configure an IGMP static member with an IP address of 225.0.0.1 on port 10 in slot 3 with
designated VLAN 3 you would enter:
-> ip multicast static-group 225.0.0.1 vlan 3 port 3/10
You can also configure a link aggregation group as an IPMS static group by entering
ip multicast static-group followed by vlan, a space, VLAN number (which must be between 0 and 4095),
a space, followed by port, a space, and the link aggregation group number.
For example, to configure link aggregation group 7 with designated VLAN 2 as a static group you would
enter:
-> ip multicast static-group 225.0.0.2 vlan 2 port 7
Removing an IGMP Static Group
To reset the port so that it is no longer an IGMP static group port, use the no form of the
ip multicast static-group
of the static group, a space, followed by vlan, a space, the VLAN number, a space, followed by port, the
slot number of the port, a slash (/), and the port number.
For example, to remove an IGMP static member with an IP address of 225.0.0.1 on port 10 in slot 3 with
designated VLAN 3 you would enter:
-> no ip multicast static-group 225.0.0.1 vlan 3 port 3/10
page 20-12
command by entering no ip multicast static-group, followed by the IP address
OmniSwitch AOS Release 7 Network Configuration Guide
Configuring IP Multicast Switching
ip multicast
static-group, followed by the
March 2011
Advertisement
Table of Contents
