Table of Contents
Advertisement
Configuring IP Multicast Switching
Configuring the Source Timeout
You can modify the source timeout from 1 to 65535 seconds by entering
followed by the new value. For example, to set the source timeout to 360 seconds on the system if no
VLAN is specified, you would enter:
-> ipv6 multicast source-timeout 60
You can also modify the source timeout on the specified VLAN by entering:
-> ipv6 multicast vlan 2 source-timeout 60
Restoring the Source Timeout
To restore the source timeout to its default value on the system if no VLAN is specified, use the
multicast source-timeout
-> ipv6 multicast source-timeout 0
Or, as an alternative, enter:
-> ipv6 multicast source-timeout
To restore the source timeout to its default value.
You can also restore the source timeout on the specified VLAN by entering:
-> ipv6 multicast vlan 2 source-timeout 0
Or, as an alternative, enter:
-> ipv6 multicast vlan 2 source-timeout
To restore the source timeout to its default value.
Enabling and Disabling the MLD Querying
By default MLD querying is disabled.The following subsections describe how to enable and disable MLD
querying by using the
Enabling the MLD Querying
You can enable the MLD querying by entering
For example, to enable the MLD querying you would enter:
-> ipv6 multicast querying enable
You can also enable the MLD querying on the specified VLAN by entering:
-> ipv6 multicast vlan 2 querying enable
Disabling the MLD Querying
You can disable the MLD querying by entering
keyword. For example, to disable the MLD querying you would enter:
-> ipv6 multicast querying
OmniSwitch AOS Release 7 Network Configuration Guide
command by entering:
ipv6 multicast querying
disable
command.
ipv6 multicast querying
ipv6 multicast querying
March 2011
Modifying IPMSv6 Parameters
ipv6 multicast source-timeout
ipv6
followed by the enable keyword.
followed by the disable
page 20-31
Advertisement
Table of Contents
