Table of Contents
Advertisement
Switch Logging Commands Overview
Disabling an IP Address from Receiving Switch Logging Output
To disable all configured output IP addresses from receiving switch logging output, enter the following
command:
-> no swlog output socket
No confirmation message appears on the screen.
To disable a specific configured output IP address from receiving switch logging output, use the same
command as above but specify an IPv4 or IPv6 address. For example:
-> no swlog output socket 174.16.5.1
page 28-10
OmniSwitch AOS Release 7 Network Configuration Guide
Using Switch Logging
March 2011
Advertisement
Table of Contents
