Table of Contents
Advertisement
sFlow
Displaying a sFlow Agent
The
show sflow agent
For example, to view the sFlow agent table, enter the show sflow agent command without specifying any
additional parameters. A screen similar to the following example is displayed, as shown below:
-> ip interface
-> show sflow agent
Agent Version
Agent IP
Note. For more information about the displays that result from these commands, see the OmniSwitch CLI
Reference Guide.
Deleting a sFlow Session
To delete a sFlow receiver session, use the release form at the end of the
ing sflow receiver, followed by the receiver index and release. For example, to delete sFlow receiver
session 6, enter:
-> sflow receiver 6 release
To delete a sFlow sampler session, use the no form of the
sampler, followed by the instance ID number, the slot number of the port to delete, a slash (/), and the port
number of the port, enter:
-> no sflow sampler 1 port 2/3
To delete a sFlow poller session, use the no form of the
poller, followed by the instance ID number, the slot number of the port to delete, a slash (/), and the port
number of the port, enter:
-> no sflow poller 3 port 1/1
page 26-32
command is used to display the receiver table.
Loopback0 127.0.0.1
= 1.3; Alcatel-Lucent; 6.1.1
= 127.0.0.1
OmniSwitch AOS Release 7 Network Configuration Guide
Diagnosing Switch Problems
sflow agent
sflow sampler
command by entering no sflow
sflow poller
command by entering no sflow
command by enter-
March 2011
Advertisement
Table of Contents
