Quick Steps for Configuring Static Link Aggregation
Note. Optional. You can verify your static link aggregation settings with the
along with the agg keyword and aggregate group ID. For example:
-> show linkagg agg 1
Static Aggregate
SNMP Id
Aggregate Number
SNMP Descriptor
Name
Admin State
Operational State
Aggregate Size
Number of Selected Ports : 4,
Number of Reserved Ports : 4,
Number of Attached Ports : 4,
Primary Port
You can also use the
"Displaying Static Link Aggregation Configuration and Statistics" on page 6-11
the show commands.
An example of what these commands look like entered sequentially on the command line on the local
switch:
-> linkagg static agg 1 size 4
-> linkagg static port 1/1-4 agg 1
-> vlan 10 port default 1
And an example of what these commands look like entered sequentially on the command line on the
remote switch:
-> linkagg static agg 1 size 4
-> linkagg static port 1/9-12 agg 1
-> vlan 10 port default 1
page 6-4
: 40000001,
: 1,
: Omnichannel Aggregate Number 1 ref 40000001 size 4,
: ,
: ENABLED,
: UP,
: 4,
: 1/1
show linkagg port
port command to display information on specific ports. See
OmniSwitch AOS Release 7 Network Configuration Guide
Configuring Static Link Aggregation
linkagg range
command
for more information on
March 2011