Configuring An Igmp Static Group; Removing An Igmp Static Group - Alcatel-Lucent OmniSwitch 6800 Series Network Configuration Manual

Hide thumbs Also See for OmniSwitch 6800 Series:

Table of Contents

Configuring IP Multicast Switching

Configuring an IGMP Static Group

You can configure a port as an IGMP static group by entering

IP address of the static group in dotted decimal notation, a space, followed by vlan, a space, VLAN

number (which must be between 0 and 4095), a space, followed by port, a space, the slot number of the

port, a slash (/), and the port number.

For example, to configure an IGMP static member with an IP address of 225.0.0.1 on port 10 in slot 3 with

designated VLAN 3 you would enter:

-> ip multicast static-group 225.0.0.1 vlan 3 port 3/10

You can also configure a link aggregation group as an IPMS static group by entering

ip multicast static-group followed by vlan, a space, VLAN number (which must be between 0 and

4095), a space, followed by port, a space, and the link aggregation group number.

For example, to configure link aggregation group 7 with designated VLAN 2 as a static group you would

-> ip multicast static-group 225.0.0.2 vlan 2 port 7

To reset the port so that it is no longer an IGMP static group port, use the no form of the

ip multicast static-group

of the static group, a space, followed by vlan, a space, the VLAN number, a space, followed by port, the

slot number of the port, a slash (/), and the port number.

For example, to remove an IGMP static member with an IP address of 225.0.0.1 on port 10 in slot 3 with

designated VLAN 3 you would enter:

-> no ip multicast static-group 225.0.0.1 vlan 3 port 3/10

OmniSwitch 6800/6850/9000 Network Configuration Guide

command by entering no ip multicast static-group, followed by the IP address

Configuring IPMS on a Switch

ip multicast

static-group, followed by the