Port Mirroring Overview
Quick Steps for Configuring Port Mirroring
1
Create a port mirroring session. Be sure to specify the port mirroring session ID, source (mirrored) and
destination (mirroring) slot/ports, and unblocked VLAN ID (optional—protects the mirroring session
from changes in Spanning Tree if the mirroring port monitors mirrored traffic on an RMON probe
belonging to a different VLAN). For example:
-> port-mirroring 6 source 2/3-9 destination 2/10 unblocked-vlan 7
Note. Optional. To verify the port mirroring configuration, enter
the port mirroring session ID number. The display is similar to the one shown below:
-> show port-mirroring status 6
Session
Mirror
Destination
----------+----------+--------------+----------+----------+---------
6.
2/10
----------+----------+--------------+----------+----------+---------
Mirror
Source
----------+----------+--------------+----------+----------+---------
6.
2/3
6.
2/4
6.
2/5
6.
2/6
6.
2/7
6.
2/8
6.
2/9
For more information about this command, see
"Port Mirroring and Monitoring Commands" chapter in the OmniSwitch CLI Reference Guide.
page 26-4
Mirror
Unblocked
Direction
Vlan
-
NONE
bidirectional
-
bidirectional
-
bidirectional
-
bidirectional
-
bidirectional
-
bidirectional
-
bidirectional
-
"Displaying Port Mirroring Status" on page 26-21
OmniSwitch AOS Release 7 Network Configuration Guide
Diagnosing Switch Problems
show port-mirroring status
Config
Oper
Status
Status
Enable
On
Enable
On
Enable
On
Enable
On
Enable
On
Enable
On
Enable
On
Enable
On
followed by
or the
March 2011