Displaying Ipms Configurations And Statistics - Alcatel-Lucent OmniSwitch AOS Release 7 Manual

Displaying IPMS Configurations and Statistics

Displaying IPMS Configurations and Statistics
Alcatel-Lucent's IP Multicast Switching (IPMS) show commands provide tools to monitor IPMS traffic
and settings and to troubleshoot problems. These commands are described below:
show ip multicast
show ip multicast group
show ip multicast neighbor
show ip multicast querier
show ip multicast port
show ip multicast source
show ip multicast tunnel
If you are interested in a quick look at IPMS groups on your switch you could use the
show ip multicast group
-> show ip multicast group
Total 3 Groups
Group Address
---------------+---------------+-----+-----+--------+-------+------+-----
231.0.0.3
234.0.0.4
229.0.0.1
Note. See the "IP Multicast Switching Commands" chapter in the OmniSwitch CLI Reference Guide for
complete documentation on IPMS show commands.
page 20-40
Displays the general IP Multicast switching and routing configuration
parameters on a switch.
Displays all detected multicast groups that have members. If you do not
specify an IP address then all multicast groups on the switch is
displayed.
Displays all neighboring multicast routers.
Displays all multicast queriers.
Displays the IPMS multicast forwarding table. If you do not specify a
multicast group IP address, then the forwarding table for all multicast
groups are displayed.
Displays the IPMS multicast source table. If you do not specify a
multicast group IP address, then the source table for all multicast groups
are displayed.
Displays the IP multicast switch and routing tunneling table entries
matching the specified IP multicast group address, or all the entries if no
IP multicast address is specified.
command. For example:
Source Address VLAN
1.0.0.5 1
0.0.0.0 1
0.0.0.0 1
OmniSwitch AOS Release 7 Network Configuration Guide
Port Mode Static
2/1 exclude no
2/1 exclude no
2/13 exclude yes
Configuring IP Multicast Switching
Count Life
1 257
1 218
0 0
March 2011