Table of Contents
Advertisement
Configuring Dynamic Link Aggregation
Note. Since individual bits with the LACPDU frame are set with the linkagg lacp agg actor admin-state
command you can set some bits on and restore other bits within the same command. For example, if you
wanted to restore bit 2 (aggregate) to its default settings and set bit 0 (active) on dynamic aggregate actor
port 49 in slot 5 you would enter:
-> no linkagg lacp agg 5/49 actor admin-state active aggregate
Modifying the Actor Port System ID
By default, the actor port system ID ( the MAC address used as the system ID on dynamic aggregate actor
ports) is 00:00:00:00:00:00. The following subsections describe how to configure a user-specified value
and how to restore the value to its default value with the
Configuring an Actor Port System ID
You can configure the actor port system ID by entering linkagg lacp port, the slot number, a slash (/), the
port number, actor system-id, and the user specified actor port system ID ( MAC address) in the
hexadecimal format of xx:xx:xx:xx:xx:xx.
For example, to modify the system ID of the dynamic aggregate actor port 3 in slot 7 to
00:20:da:06:ba:d3, enter:
-> linkagg lacp port 7/3 actor system-id 00:20:da:06:ba:d3
For example, to modify the system ID of the dynamic aggregate actor port 3 in slot 7 to
00:20:da:06:ba:d3 and document that the port is 10 Mbps Ethernet you would enter:
-> linkagg lacp port 7/3 actor system-id 00:20:da:06:ba:d3
Restoring the Actor Port System ID
To remove a user-configured system ID from a dynamic aggregate group actor port configuration, use the
no form of the
linkagg lacp port actor system-id
number, a slash (/), the port number, and actor system-id keyword.
For example, to remove a user-configured system ID from dynamic aggregate actor port 3 in slot 7, enter:
-> linkagg lacp port 7/3 actor system-id
Modifying the Actor Port System Priority
By default, the actor system priority is 0. The following subsections describe how to configure a
user-specified value and how to restore the value to its default value with the
system-priority
command.
Configuring an Actor Port System Priority
You can configure the actor system priority to a value by entering lacp agg, the slot number, a slash (/),
the port number, actor system priority, and the user-specified actor port system priority.
For example, to modify the system priority of dynamic aggregate actor port 5 in slot 2 to 200 you would
enter:
-> linkagg lacp port 2/5 actor system-priority 200
For example, to modify the system priority of dynamic aggregate actor port 5 in slot 2 to 200, enter:
OmniSwitch AOS Release 7 Network Configuration Guide
Modifying Dynamic Link Aggregate Group Parameters
linkagg lacp port actor system-id
command by entering no linkagg lacp agg, the slot
March 2011
command.
linkagg lacp port actor
page 7-19
Advertisement
Table of Contents
