Table of Contents
Advertisement
Modifying IPMSv6 Parameters
Modifying IPMSv6 Parameters
The table in
"IPMSv6 Default Values" on page 20-4
following sections describe how to use CLI commands to modify these parameters.
Modifying the MLD Query Interval
The default IPMSv6 query interval (i.e., the time between MLD queries) is 125 in seconds. The following
subsections describe how to configure a user-specified query interval value and restore it by using the
ipv6 multicast query-interval
Configuring the MLD Query Interval
You can modify the MLD query interval from 1 to 65535 in seconds by entering
ipv6 multicast query-interval
60 seconds on the system if no VLAN is specified, you would enter:
-> ipv6 multicast query-interval 160
You can also modify the MLD query interval on the specified VLAN by entering:
-> ipv6 multicast vlan 2 query-interval 160
Restoring the MLD Query Interval
To restore the MLD query interval to its default value on the system if no VLAN is specified, use the
multicast query-interval
-> no ipv6 multicast query-interval
You can also restore the MLD query interval on the specified VLAN by entering:
-> no ipv6 multicast vlan 2 query-interval
Modifying the MLD Last Member Query Interval
The default MLD last member query interval (i.e., the time period to reply to an MLD query message sent
in response to a leave group message) is 1000 in milliseconds. The following subsections describe how to
configure the MLD last member query interval and restore it by using the
ipv6 multicast last-member-query-interval
Configuring the MLD Last Member Query Interval
You can modify the MLD last member query interval from 1 to 65535 in milliseconds by entering
ipv6 multicast last-member-query-interval
member query interval to 600 milliseconds on the system if no VLAN is specified, you would enter:
-> ipv6 multicast last-member-query-interval 2200
You can also modify the MLD last member query interval on the specified VLAN by entering:
-> ipv6 multicast vlan 3 last-member-query-interval 2200
page 20-28
command.
followed by the new value. For example, to set the MLD query interval to
command by entering:
command.
followed by the new value. For example, to set the MLD last
OmniSwitch AOS Release 7 Network Configuration Guide
Configuring IP Multicast Switching
lists default values for IPMSv6 parameters. The
ipv6
March 2011
Advertisement
Table of Contents
