Table of Contents
Advertisement
Configuring VLAN Stacking
Commands
ethernet-service svlan
ethernet-service service-name
ethernet-service svlan nni
ethernet-service nni
ethernet-service sap
ethernet-service sap uni
ethernet-service sap cvlan
ethernet-service sap-profile
ethernet-service sap sap-profile
ethernet-service uni-profile
ethernet-service uni uni-profile
Configuring SVLANs
SVLANs carry customer traffic and are not configurable or modifiable using standard VLAN commands.
The
ethernet-service svlan
specify the type of SVLAN: svlan for customer traffic.For example, the following command creates a
customer SVLAN:
-> ethernet-service svlan 300
Similar to standard VLANs, the administrative and Spanning Tree status for the SVLAN is enabled by
default and the SVLAN ID is used as the default name. The ethernet-service svlan command also
provides parameters for changing any of these status values and the name. These are the same parameters
that are used to change these values for standard VLANs. For example, the following commands change
the administrative and Spanning Tree status and name for SVLAN 300:
-> ethernet-service svlan 300 disable
-> ethernet-service svlan 300 stp disable
-> ethernet-service svlan 300 name "Customer A"
To delete an SVLAN from the switch configuration, use the no form of the ethernet-service svlan
command. For example, to delete SVLAN 300 enter:
-> no ethernet-service svlan 300
OmniSwitch AOS Release 7 Network Configuration Guide
Used for ...
Creating SVLANs to tunnel customer traffic.
Creating a VLAN Stacking service and associat-
ing the service with an SVLAN.
Configuring a switch port as a VLAN Stacking
NNI port and associating the NNI port with an
SVLAN.
Configuring a vendor TPID and legacy Spanning
Tree support for an NNI port.
Creating a VLAN Stacking SAP and associates
the SAP with a VLAN Stacking service name.
Configuring a switch port as a VLAN Stacking
UNI port and associating the UNI port with a
VLAN Stacking SAP.
Specifying the type of customer traffic that is
accepted on SAP UNI ports.
Configures traffic engineering attributes for cus-
tomer traffic that is accepted on SAP UNI ports.
Associates a VLAN Stacking SAP with a profile.
Configures how protocol control frames are pro-
cessed on VLAN Stacking UNI ports.
Associates a VLAN Stacking UNI port with a
profile.
command is used to create an SVLAN. This command provides parameters to
Configuring VLAN Stacking Services
March 2011
page 27-11
Advertisement
Table of Contents
