Table of Contents
Advertisement
Port Mapping Specifications
Port Mapping Specifications
Platforms Supported
Ports Supported
Port Mapping Sessions
Port Mapping Defaults
The following table shows port mapping default values.
Parameter Description
Mapping Session
Creation
Mapping Status
configuration
Port Mapping Direction
Port Mapping Unknown
Unicast Flooding
Quick Steps for Configuring Port Mapping
Follow the steps below for a quick tutorial on configuring port mapping sessions. Additional information
on how to configure each command is given in the subsections that follow.
1
Create a port mapping session with the user ports, network ports, or both user ports and network ports
with the
port-mapping user-port network-port
-> port-mapping 8 user-port 1/2 network-port 1/3
2
Enable the port mapping session with the
-> port-mapping 8 enable
Note. You can verify the configuration of the port mapping session by entering
followed by the session ID.
-> show port-mapping 8
SessionID
-----------+----------------+------------------
8
page 24-2
OmniSwitch 10K
Ethernet (10 Mbps)
Fast Ethernet (100 Mbps)
Gigabit Ethernet (1000 Mbps)
10 Gigabit Ethernet (10000 Mbps)
16
CLI Command
port-mapping user-port network-port
port-mapping
port-mapping [unidirectional | bidi-
rectional]
port-mapping unknown-unicast-
flooding
port-mapping
USR-PORT
NETWORK-PORT
1/2
1/3
OmniSwitch AOS Release 7 Network Configuration Guide
Default Value/Comments
No mapping sessions
Disabled
Bidirectional
Enabled
command. For example:
command. For example:
Configuring Port Mapping
show port-mapping
March 2011
Advertisement
Table of Contents
