Table of Contents
Advertisement
•
Source IP address or source network group
•
Destination IP address or destination network group
•
IP protocol
•
ICMP code
•
ICMP type
•
Source TCP/UDP port
•
Destination TCP/UDP port or service or service group
Layer 3 ACL: Example 1
In this example, the default routed disposition is accept (the default). Since the default is accept, the qos
default routed disposition command would only need to be entered if the disposition had previously been
set to deny. The command is shown here for completeness.
-> qos default routed disposition accept
-> policy condition addr2 source ip 192.68.82.0 source ip port 23 ip protocol 6
-> policy action Block disposition deny
-> policy rule FilterL31 condition addr2 action Block
Traffic with a source IP address of 192.68.82.0, a source IP port of 23, using protocol 6, matches condi-
tion addr2, which is part of FilterL31. The action for the filter (Block) is set to deny traffic. The flow is
dropped on the switch.
Note that although this example contains only Layer 2 conditions, it is possible to combine Layer 2 and
Layer 3 conditions in the same policy.
Layer 3 ACL: Example 2
This example uses condition groups to combine multiple IP addresses in a single condition. The default
disposition is set to deny.
-> qos default routed disposition deny
-> policy network group GroupA 192.60.22.1 192.60.22.2 192.60.22.0
-> policy condition cond7 destination network group GroupA
-> policy action Ok disposition accept
-> policy rule FilterL32 condition cond7 action Ok
In this example, a network group, GroupA, is configured with three IP addresses. Condition cond7
includes GroupA as a destination group. Flows coming into the switch destined for any of the specified IP
addresses in the group matches rule FilterL32. FilterL32 is configured with an action (Ok) to allow the
traffic on the switch.
Note that although this example contains only Layer 2 conditions, it is possible to combine Layer 2 and
Layer 3 conditions in the same policy.
OmniSwitch AOS Release 7 Network Configuration Guide
March 2011
page 21-61
Advertisement
Table of Contents
