Creating Port Groups - Alcatel-Lucent OmniSwitch AOS Release 7 Manual

Note. MAC group configuration is not active until the qos apply command is entered.
To delete addresses from a MAC group, use no and the relevant address(es):
-> policy mac group macgrp2 no 08:00:20:00:00:00
This command specifies that MAC address 08:00:20:00:00:00 is deleted from macgrp2 at the next qos
apply.
To delete a MAC group, use the no form of the policy mac group command with the relevant MAC
group name. The group must not be associated with any policy condition. For example:
-> no policy mac group macgrp2
MAC group macgrp2 is deleted at the next qos apply. If macgrp2 is associated with a policy
condition, an error message displays instead:
ERROR: macgrp2 is being used by condition 'cond3'
In this case, remove the MAC group from the condition first; then enter the no policy mac group
command. For example:
-> policy condition cond3 no source mac group
-> no policy mac group macgrp2
The policy condition command removes the MAC group from the condition. See
tions" on page 21-41
deleted at the next qos apply.

Creating Port Groups

Port groups are made up of slot and port number combinations. Note that there are many built-in port
groups, one for each slot on the switch. Built-in port groups are subdivided by slice. The built in groups
are named by slot (Slot01, Slot02, etc.). To view the built-in groups, use the
command.
To create a port group, use the
-> policy port group techpubs 2/1 3/1 3/2 3/3
The port group can then be associated with a condition through the policy condition command. Note that
the policy condition specifies whether the group must be used for source or destination. For example:
-> policy condition cond4 source port group techpubs
This command creates a condition called cond4 that can be used in a policy rule to classify traffic by
source port number. The port numbers are specified in the port group. For more information about config-
uring conditions, see
Note. Port group configuration is not active until the qos apply command is entered.
To delete ports from a port group, use no and the relevant port number(s).
-> policy port group techpubs no 2/1
OmniSwitch AOS Release 7 Network Configuration Guide
for more information about configuring policy conditions. The MAC group is
policy port group
"Creating Policy Conditions" on page
command. For example:
21-41.
March 2011
"Creating Policy Condi-
show policy port group
page 21-53