802.1Ab Specifications; 802.1Ab Defaults Table; Quick Steps For Configuring 802.1Ab - Alcatel-Lucent OmniSwitch AOS Release 7 Manual

802.1AB Specifications

•
"Verifying 802.1AB Configuration" on page
802.1AB Specifications
Platforms Supported
IEEE Specification
Maximum number of network policies that
can be associated with a port
Maximum number of network policies
that can be configured on the switch

802.1AB Defaults Table.

The following table shows the default settings of the configurable 802.1AB parameters.
Parameter Description
Transmit time interval for LLDPDUs
Transmit hold multiplier value
Transmit delay
Reinit delay
Notification interval
LLDPDUs transmission
Per port notification
Management TLV
802.1 TLV
802.3 TLV
LLDP Media Endpoint Device

Quick Steps for Configuring 802.1AB

1
To enable the transmission and the reception of LLDPDUs on a port, use the
For example:
-> lldp port 2/47 lldpdu tx-and-rx
2
To control per port notification status about a change in a remote device associated to a port, use the
lldp notification command. For example:
-> lldp port 2/47 notification enable
page 10-2
10-14.
OmniSwitch 10K
IEEE 802.1AB-2005 Station and Media Access
Control Connectivity Discovery
8
32
Command
lldp transmit interval
lldp transmit hold-multiplier
lldp transmit delay
lldp reinit delay
lldp notification interval
lldp lldpdu
lldp notification
lldp tlv management
lldp tlv dot1
lldp tlv dot3
lldp tlv med
OmniSwitch AOS Release 7 Network Configuration Guide
Configuring 802.1AB
Default Value/Comments
30 seconds
4
2 seconds
2 seconds
5 seconds
Transmission and Reception
Disable
Disable
Disable
Disable
Disable
lldp lldpdu command.
March 2011