Alcatel-Lucent OmniSwitch AOS Release 7 Manual page 546

This command specifies that port 2/1 is deleted from the techpubs port group at the next qos apply.
To delete a port group, use the no form of the policy port group command with the relevant port group
name. The port group must not be associated with any policy condition. For example:
-> no policy port group techpubs
The port group techpubs are deleted at the next qos apply. If techpubs is associated with a policy
condition, an error message displays instead:
ERROR: techpubs is being used by condition 'cond4'
In this case, remove the port group from the condition first; then enter the no policy port group
command. For example:
-> policy condition cond4 no source port group
-> no policy port group techpubs
The policy condition command removes the port group from the policy condition. (See
Conditions" on page 21-41
deleted at the next qos apply.
page 21-54
for more information about configuring policy conditions.) The port group is
OmniSwitch AOS Release 7 Network Configuration Guide
"Creating Policy
March 2011