Diagnosing Switch Problems
Note. Port mirroring session parameters cannot be modified when a mirroring session is enabled. Before
you can modify parameters, the mirroring session must be disabled.
To disable a port mirroring session, enter the port-mirroring command, followed by the port mirroring
session ID number and the keyword disable. The following command disables port mirroring session 6
(turning port mirroring off):
-> port-mirroring 6 disable
Displaying Port Mirroring Status
To display port mirroring status, use the
mirroring sessions, enter:
-> show port-mirroring status 6
Session
Mirror
Destination
----------+----------+--------------+----------+----------+---------
1.
2/1
----------+----------+--------------+----------+----------+---------
Mirror
Source
----------+----------+--------------+----------+----------+---------
1.
1/1
1.
1/2
1.
1/3
1.
1/4
1.
1/5
Deleting A Mirroring Session
The no form of the
port-mirroring
configuration between a mirrored port and a mirroring port.
To delete a mirroring session, enter the no port-mirroring command, followed by the port mirroring
session ID number. For example:
-> no port-mirroring 6
In this example, port mirroring session 6 is deleted.
Note. The port mirroring session identifier must always be specified.
OmniSwitch AOS Release 7 Network Configuration Guide
show port-mirroring status
Mirror
Unblocked
Direction
Vlan
-
NONE
bidirectional
-
bidirectional
-
bidirectional
-
bidirectional
-
bidirectional
-
command can be used to delete a previously created mirroring session
March 2011
command. To display all port
Config
Oper
Status
Status
Enable
On
Enable
On
Enable
On
Enable
On
Enable
On
Enable
On
Port Mirroring
page 26-21