Table of Contents
Advertisement
Configuring Static Link Aggregation
Quick Steps for Configuring Static Link
Aggregation
Follow the steps below for a quick tutorial on configuring a static aggregate link between two switches.
Additional information on how to configure each command is given in the subsectio ns that follow.
1
Create the static aggregate link on the local switch with the
example:
-> linkagg static agg 1 size 4
2
Assign all the necessary ports with the
-> linkagg static port 1/1-4 agg 1
3
Create a VLAN for this static link aggregate group with the vlan members command. For example:
-> vlan 10 members port 1
4
Create the equivalent static aggregate link on the remote switch with the
command. For example:
-> linkagg static agg 1 size 4
5
Assign all the necessary ports with the
-> linkagg static port 1/9-12 agg 1
6
Create a VLAN for this static link aggregate group with the vlan members command. For example:
-> vlan 10 members default 1
OmniSwitch AOS Release 7 Network Configuration Guide
Quick Steps for Configuring Static Link Aggregation
linkagg static agg size
linkagg static port agg
command. For example:
linkagg static port agg
command. For example:
March 2011
command. For
linkagg static agg size
page 6-3
Advertisement
Table of Contents
