Alcatel-Lucent OmniSwitch AOS Release 7 Manual page 154

Network configuration guide
Hide thumbs Also See for OmniSwitch AOS Release 7:
Table of Contents

Advertisement

Modifying Dynamic Link Aggregate Group Parameters
Keyword
collect
distribute
default
expire
Note. Specifying none removes all administrative states from the LACPDU configuration. For example:
-> linkagg lacp port 7/49 partner admin-state none
For example, to set bits 0 (active) and 2 (aggregate) on dynamic aggregate partner port 49 in slot 7, enter:
-> linkagg lacp port 7/49 partner admin-state active aggregate
For example, to set bits 0 (active) and 2 (aggregate) on dynamic aggregate partner port 49 in slot 7 and
document that the port is a Gigabit Ethernet port, enter:
-> linkagg lacp port 7/49 partner admin-state active aggregate
Restoring Partner Port System Administrative State Values
To restore LACPDU bit settings to their default values use the no form of the
admin-state
command and enter the active, timeout, aggregate, or synchronize keywords.
For example, to restore bits 0 (active) and 2 (aggregate) to their default settings on dynamic aggregate
partner port 1 in slot 7, enter:
-> no linkagg lacp port 7/1 partner admin-state active aggregate
page 7-22
Definition
Specifying this keyword has no effect because the system always
determines its value. When this bit (bit 4) is set by the system,
incoming LACPDU frames are collected from the individual ports that
make up the dynamic aggregate group.
Specifying this keyword has no effect because the system always deter-
mines its value. When this bit (bit 5) is set by the system, distributing
outgoing frames on the port is disabled.
Specifying this keyword has no effect because the system always deter-
mines its value. When this bit (bit 6) is set by the system, it indicates
that the partner is using defaulted actor information administratively
configured for the partner.
Specifying this keyword has no effect because the system always deter-
mines its value. When this bit (bit 7) is set by the system, the actor can-
not receive LACPDU frames.
OmniSwitch AOS Release 7 Network Configuration Guide
Configuring Dynamic Link Aggregation
linkagg lacp agg partner
March 2011

Advertisement

Table of Contents
loading

This manual is also suitable for:

Omniswitch aos 7

Table of Contents