Search:serial:i2S:pattern:data - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

:SEARch:SERial:I2S:PATTern:DATA

Command Syntax
:SEARch:SERial:I2S:PATTern:DATA <string>
<string> ::= "n" where n ::= 32-bit integer in signed decimal
<string> ::= "nn...n" where n ::= {0 | 1 | X} when <base> = BINary
<string> ::= "0xnn...n" where n ::= {0,..,9 | A,..,F | X}
The :SEARch:SERial:I2S:PATTern:DATA command specifies the data word
value when searching for I2S events.
The base of the value entered with this command is specified using the
:SEARch:SERial:I2S:PATTern:FORMat command.
Query Syntax
:SEARch:SERial:I2S:PATTern:DATA?
The :SEARch:SERial:I2S:PATTern:DATA? query returns the current data
word value setting.
Return Format
<string><NL>
<string> ::= "n" where n ::= 32-bit integer in signed decimal
<string> ::= "nn...n" where n ::= {0 | 1 | X} when <base> = BINary
<string> ::= "0xnn...n" where n ::= {0,..,9 | A,..,F | X}
See Also •
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1138)
when <base> = DECimal
when <base> = HEX
when <base> = DECimal
when <base> = HEX
Chapter 28, ":SEARch Commands," starting on page 777
":SEARch:SERial:I2S:MODE"
":SEARch:SERial:I2S:PATTern:FORMat"
on page 822
on page 824
28
:SEARch Commands
823