Power:signals:vsteady:transient - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

24
:POWer Commands

:POWer:SIGNals:VSTeady:TRANsient

Command Syntax
:POWer:SIGNals:VSTeady:TRANsient <value>[suffix]
<value> ::= Expected steady state output Voltage value in NR3 format
[suffix] ::= {V | mV}
The :POWer:SIGNals:VSTeady:TRANsient command specifies the expected
steady state output DC voltage of the power supply for transient response
analysis.
This value is used along with the overshoot percentage to specify the
settling band for the transient response and to adjust the vertical scale of
the oscilloscope.
Query Syntax
:POWer:SIGNals:VSTeady:TRANsient?
The :POWer:SIGNals:VSTeady:TRANsient query returns the expected steady
state voltage setting.
Return Format
<value><NL>
<value> ::= Expected steady state output Voltage value in NR3 format
See Also
•
•
•
•
•
•
•
580
(see page 1138)
":POWer:TRANsient:APPLy"
":POWer:SIGNals:AUTosetup"
":POWer:SIGNals:DURation:TRANsient"
":POWer:SIGNals:IEXPected"
":POWer:SIGNals:OVERshoot"
":POWer:SIGNals:SOURce:CURRent<i>"
":POWer:SIGNals:SOURce:VOLTage<i>"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 591
on page 564
on page 572
on page 573
on page 574
on page 581
on page 582