Sbus<N>:Flexray:autosetup - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

:SBUS<n>:FLEXray:AUTosetup
Command Syntax
:SBUS<n>:FLEXray:AUTosetup
The :SBUS<n>:FLEXray:AUTosetup command automatically configures
oscilloscope settings to facilitate FlexRay triggering and serial decode.
• Sets the selected source channel's impedance to 50 Ohms.
• Sets the selected source channel' s probe attenuation to 10:1.
• Sets the trigger level (on the selected source channel) to - 300 mV.
• Turns on trigger Noise Reject.
• Turns on Serial Decode.
• Sets the trigger to the specified serial bus (n of SBUS<n>).
See Also •
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1138)
"Introduction to :TRIGger Commands"
":SBUS<n>:FLEXray:TRIGger"
":SBUS<n>:FLEXray:BAUDrate"
":TRIGger[:EDGE]:LEVel"
":SBUS<n>:FLEXray:SOURce"
on page 877
on page 679
on page 672
on page 903
on page 678
27
:SBUS<n> Commands
671