Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual page 417

Vtop. If you want to move the delay measurement point nearer to Vtop or
Vbase, you must change the threshold values with the :MEASure:DEFine
THResholds command.
Return Format
<value><NL>
<value> ::= floating-point number delay time in seconds in NR3 format
See Also •
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
"Introduction to :MEASure Commands"
":MEASure:DEFine" on page 413
":MEASure:PHASe" on page 434
:MEASure Commands
on page 406
20
417