Trigger:delay:arm:slope - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

31
:TRIGger Commands

:TRIGger:DELay:ARM:SLOPe

Command Syntax
:TRIGger:DELay:ARM:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:DELay:ARM:SLOPe command specifies rising (POSitive) or
falling (NEGative) for the arming edge in the Edge Then Edge triggger.
Query Syntax
:TRIGger:DELay:ARM:SLOPe?
The :TRIGger:DELay:ARM:SLOPe? query returns the current arming edge
slope setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also
•
•
•
890
(see page 1138)
"Introduction to :TRIGger Commands"
":TRIGger:DELay:ARM:SOURce"
":TRIGger:DELay:TDELay:TIME"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 877
on page 891
on page 892