Mtest:average - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

:MTESt:AVERage

Command Syntax
:MTESt:AVERage <on_off>
<on_off> ::= {{1 | ON} | {0 | OFF}}
The :MTESt:AVERage command enables or disables averaging. When ON,
the oscilloscope acquires multiple data values for each time bucket, and
averages them. When OFF, averaging is disabled. To set the number of
averages, use the :MTESt:AVERage:COUNt command described next.
The :MTESt:AVERage command is obsolete and is provided for backward compatibility to
N O T E
previous oscilloscopes. Use the :ACQuire:TYPE AVERage command (see
Query Syntax
:MTESt:AVERage?
The :MTESt:AVERage? query returns the current setting for averaging.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also •
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1138)
"Introduction to :MTESt Commands"
":MTESt:AVERage:COUNt"
Obsolete and Discontinued Commands
on page 491
on page 1082
35
page 239) instead.
1081