Display:order - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

35
Obsolete and Discontinued Commands

:DISPlay:ORDer

Query Syntax
:DISPlay:ORDer?
The :DISPlay:ORDer? query returns a list of digital channel numbers in
screen order, from top to bottom, separated by commas. Busing is
displayed as digital channels with no separator. For example, in the
following list, the bus consists of digital channels 4 and 5: DIG1, DIG4
DIG5, DIG7.
The :DISPlay:ORDer command is an obsolete command provided for compatibility to
N O T E
previous oscilloscopes. This command is only available on the MSO models.
Return Format
<order><NL>
<order> ::= Unquoted ASCII string
A return value is included for each digital channel. A return value of NONE indicates that a
N O T E
channel is turned off.
See Also •
Example Code
See complete example programs at:
starting on page 1147
1056
(see page 1138)
":DIGital<d>:POSition"
' DISP_ORDER - Set the order the channels are displayed on the
' analyzer. You can enter between 1 and 32 channels at one time.
' If you leave out channels, they will not be displayed.
' Display ONLY channel 0 and channel 10 in that order.
myScope.WriteString ":DISPLAY:ORDER 0,10"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 293
Chapter 40, "Programming Examples,"