Waveform:data - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

:WAVeform:DATA

Query Syntax
:WAVeform:DATA?
The :WAVeform:DATA query returns the binary block of sampled data
points transmitted using the IEEE 488.2 arbitrary block data format. The
binary data is formatted according to the settings of the
:WAVeform:UNSigned, :WAVeform:BYTeorder, :WAVeform:FORMat, and
:WAVeform:SOURce commands. The number of points returned is
controlled by the :WAVeform:POINts command.
In BYTE or WORD waveform formats, these data values have special
meaning:
• 0x00 or 0x0000 — Hole. Holes are locations where data has not yet been
• 0x01 or 0x0001 — Clipped low. These are locations where the waveform
• 0xFF or 0xFFFF — Clipped high. These are locations where the
Return Format
<binary block data><NL>
See Also
• For a more detailed description of the data returned for different
•
•
•
•
•
•
•
Example Code
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1138)
acquired.
Another situation where there can be zeros in the data, incorrectly, is
when programming over telnet port 5024. Port 5024 provides a
command prompt and is intended for ASCII transfers. Use telnet port
5025 instead.
is clipped at the bottom of the oscilloscope display.
waveform is clipped at the top of the oscilloscope display.
acquisition types, see:
page 961
":WAVeform:UNSigned"
":WAVeform:BYTeorder"
":WAVeform:FORMat"
":WAVeform:POINts" on page 972
":WAVeform:PREamble"
":WAVeform:SOURce"
":WAVeform:TYPE" on page 986
' QUERY_WAVE_DATA - Outputs waveform data that is stored in a buffer.
' Query the oscilloscope for the waveform data.
myScope.WriteString ":WAV:DATA?"
' READ_WAVE_DATA - The wave data consists of two parts: the header,
' and the actual waveform data followed by a new line (NL) character.
' The query data has the following format:
"Introduction to :WAVeform Commands"
on page 987
on page 967
on page 971
on page 976
on page 981
32
:WAVeform Commands
on
969