Trigger:transition:slope - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

31
:TRIGger Commands

:TRIGger:TRANsition:SLOPe

Command Syntax
:TRIGger:TRANsition:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:TRANsition:SLOPe command specifies a POSitive rising edge
or a NEGative falling edge.
Query Syntax
:TRIGger:TRANsition:SLOPe?
The :TRIGger:TRANsition:SLOPe? query returns the current rise/fall time
trigger slope setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also
•
•
•
940
(see page 1138)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 886
":TRIGger:TRANsition:SOURce"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 877
on page 941