Sbus<N>:Uart:base - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

:SBUS<n>:UART:BASE
Command Syntax
:SBUS<n>:UART:BASE <base>
<base> ::= {ASCii | BINary | HEX}
The :SBUS<n>:UART:BASE command determines the base to use for the
UART decode and Lister display.
Query Syntax
:SBUS<n>:UART:BASE?
The :SBUS<n>:UART:BASE? query returns the current UART decode and
Lister base setting.
Return Format
<base><NL>
<base> ::= {ASCii | BINary | HEX}
Errors
•
See Also
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1138)
"- 241, Hardware missing"
"Introduction to :SBUS<n> Commands"
":SBUS<n>:UART Commands"
on page 1099
on page 629
on page 754
27
:SBUS<n> Commands
757