Host Configuration; Options Shown By -Z - Qlogic SANsurfer FC/CNA HBA CLI User Manual

4–Non-Interactive Commands
Display System Information (Command Line Options -g, -z, and -tp)
Port Information

Host Configuration

Use these options to show the information for one or all of the adapter ports in the
system. The -z option shows the combination of the commands listed in
Table 4-1. The commands are listed in alphabetical order.
CLI
-c
-e
-fg
4-4
Port Type
Port State
Physical Port Number (switch port number), including:
Port state
Port type
TX port type
Port module type
Attached Port (QLogic adapter, tape device, or disk device connected
to the switch physical port), including:
Target/initiator
Node name
Port name
Vendor ID
Product ID (if applicable)
Product revision (if applicable)
Product serial number (if applicable)
Adapter model (if applicable)
Adapter serial number (if applicable)
Adapter alias (if applicable)
Port alias (if applicable)
Driver version
Firmware version
Total number of devices (if applicable)
Host (if applicable)
Table 4-1. Options Shown by -z
Description
adapter
Show settings
Configure boot device
View driver settings
.
See User Guide Section
"-c (Show Parameter Settings)" on
page 4-8
"-e (Boot Device View | Select | Dis-
able)" on page 4-11
"-fg (Show Driver Settings)" on
page 4-16
SN0054614-00 K