B (Save Or Update The Flash Bios Or Fcode) - Qlogic SANsurfer FC/CNA HBA CLI User Manual

NOTE:
To view the adapter port's LED beacon state, type:
# scli -a (<hba instance> | <hba wwpn>)(view | ?)
When the adapter's LED is flashing, the following message appears:
HBA Port x - LED Flashing is ON.
When the adapter's LED is not flashing, the following message appears:
HBA Port x - LED Flashing is OFF.
In Solaris SPARC, include double quotes around the question mark (?) if the
system is running with a csh or tsch shell. For example:
# scli -a <hba> "?"
To start or stop flashing the adapter's LED beacon, type:
# scli -a (<hba instance> | <hba wwpn>)
SANsurfer FC/CNA HBA CLI toggles the LED's state. If the LED is flashing, the
flashing stops. If the LED is not flashing, the flashing begins.
If SANsurfer FC/CNA HBA CLI is not in silent mode (see
page 4-45), one of the following messages appears to indicate the LED's current
state:
The LED Flashing for <hba instance> <hba wwpn> has been turned
ON
The LED Flashing for <hba instance> <hba wwpn> has been turned
OFF
The hba instance and hba wwpn variables must match the command input
parameter.
-b
(Save or Update the Flash BIOS or FCode)
Use the -b command to:
Update the BIOS or FCode from a file (1).
Save the BIOS or FCode to a file (2).
SN0054614-00 K
Adapter must not be in silent mode. See
to issue a response to this command.
The -a feature is not supported on QLA22xx adapters or QLE8042
adapter.
4–Non-Interactive Commands
Command Summary
"-s (Silent Mode)" on page 4-45
"-s (Silent Mode)" on
4-7