Qlogic SANsurfer FC/CNA HBA CLI User Manual page 320

D–Help Commands
Command
Line Action
–q ( <hba instance> | <hba wwpn> |
<all> ) [ –targets | –t ]
-qos <hba instance>|<hba wwpn> info
--vp <all> [--spd|--per]
-qos <hba instance>|<hba wwpn> info
--vp <vport wwpn>
-qos <hba instance>|<hba wwpn> {--vp
<vport wwpn> --pri <prior-
ity>|--bwspd <speed>|--bwper
<percent>| --lock <lock
value>|--enable <enable
value>}
–r ( <hba instance> | <hba wwpn> )
save <file name>
–r ( <hba instance> | <hba wwpn> |
<all> ) <file name>
–s —
( <hba instance> | <hba wwpn> ) Shows the information about devices (disks
–t
–t ( <hba instance> | <hba wwpn> )
( <target wwpn> | <target
portid> )
–t [ <all> ]
–tb ( <hba instance> | <hba wwpn>
){ ( <target wwpn> ) } <beacon
mode>
–tp | —
–topology
]
-u ( <hba instance> | <hba wwpn> |
<all> ) <file name>
D-8
Table D-2. Help Commands (Continued)
Arguments Function
Shows the current iiDMA settings of all tar-
gets on an adapter port or all adapters.
Shows current QoS settings for all virtual
ports on a physical adapter port.
Shows current QoS settings for a specific
virtual port on a physical adapter port.
Modifies QoS settings for specified virtual
ports.
Saves the current adapter parameters of an
adapter port to a file.
Updates the adapter parameters of an
adapter port or all adapters from a file.
Suppresses the output. This option can be
combined with other options. However, this
option must be at the beginning or at the
end of the command line.
or tapes) attached to an adapter port.
Shows the information about a device (disk
or tape) attached to an adapter port.
Shows the information about devices (disks
or tapes) attached to all adapters.
Locates a specific device or multiple
devices in a JBOD. This feature is sup-
ported only by devices within a JBOD.
Shows the current topology (Host view).
Updates the firmware preload area of the
adapter.
SN0054614-00 K