Configuring The Iidma Settings - Qlogic SANsurfer FC/CNA HBA CLI User Manual

3–Interactive Commands
Target Link Speed or iiDMA Settings Menu (Command Line Option -q)
Target Link Speed Settings
<target id>
<target portid>
<target wwnn>
<target wwpn>
-targets | -t

Configuring the iiDMA Settings

Use the intelligent interleaved direct memory access (iiDMA) menu to select the
intelligent interleave factor settings per adapter type and device.
NOTE:
The iiDMA options are not available for the QLE8042 adapter with FCoE
engine.
To configure iiDMA settings:
1. From the SANsurfer FC/CNA HBA CLI main menu, select iiDMA Settings.
2. Select the adapter that you want to apply the iiDMA update.
3. Select one of the following options:
4. To use Basic Configuration:
a.
b.
c.
3-48
Table 3-3. Target Link Speed Settings (Continued)
Target ID.
Target world wide port name, format xx-xx-xx or
xxxxxx.
Target World Wide Node Name, format
xx-xx-xx-xx-xx-xx-xx-xx or xxxxxxxx.
Target world wide port name, format
xx-xx-xx-xx-xx-xx-xx-xx or xxxxxxxx.
All targets.
Basic Configuration if you want to apply the iiDMA update to all
devices attached to this adapter.
Advanced Configuration if you want to select an apply different
iiDMA update to each device attached to this adapter.
Select the adapter.
Select the iiDMA from the intelligent interleave factor speed list (1
Gbps, 2 Gbps, 4 Gbps, or 8 Gbps) to all attached devices.
Choose one of the following options:
To apply the new settings to all attached devices, select Yes.
The following is returned:
Description
SN0054614-00 K