3–Fibre Channel Configuration
Configuring and Verifying FA-BLD
Setting the Static FA-PWWN from the Switch
Figure 3-21
Figure 3-21. Setting the Static FA-PWWN from the Brocade Switch
After refreshing the Brocade switch, the Device Port WWN appears in Web Tools
as shown in
Figure 3-22. Device Port WWN (Static) for Brocade Switch
Configuring and Verifying FA-BLD
This section provides the following information on fabric-assigned boot LUN
discovery (FA-BLD):
Configuring FA-BLD from the Adapter
Verifying that FA-BLD is Operational
Adapter Side Restrictions
Configuring FA-BLD from the Adapter
On the adapter side, follow these procedures to configure fabric-assigned boot
LUN discovery (FA-BLD) in the QConvergeConsole GUI and QConvergeConsole
CLI.
Enabling Host Bus Adapter Port BIOS and Fabric-assigned Boot LUN with
QConvergeConsole GUI
To enable the Host Bus Adapter Port BIOS:
1.
In QConvergeConsole GUI, select the Host tab in the left pane.
2.
In the system tree, expand the adapter node and then select a port node.
shows the static FA-PWWN setting from the Brocade switch.
Figure
3-22.
68
BK3254601-00 C