Start Diagnostic Test (Read/Write Buffer) - Qlogic SANsurfer FC/CNA HBA CLI User Manual

3–Interactive Commands
Diagnostics Menu (Command Line Options -kl, -kr, and -dm)
4. The Read/Write Buffer Test Menu appears. Select one of the following
options:
1.
2.
3.
4.
5.
6. If you selected Configure Test Parameters in
Menu (R/W Buffer) appears. For example:
See
values. For each parameter you want to change, follow these steps:
a.
b.
c.

Start Diagnostic Test (Read/Write Buffer)

When you select Start Diagnostics Test for the read/write buffer test, the CLI
shows the test configuration and results.
The following warning message appears:
Warning: The Diagnostic Loopback and Read/Write Buffer tests
require that the HBA has no outstanding input and output
3-84
1 = Loopback Test
2 = Read/Write Buffer Test
Display Test Parameters. Type 1 to show the current parameter
values.
Reset Test Parameters. Type 2 to return all parameters to their
default values.
Configure Test Parameters. Type 3 to customize any or all of the
parameter values. Continue with
Start Diagnostics Test. Type 4 to run the read/write buffer test with
the current parameter values. To see these values, type 1 (Display
Test Parameters).
Return to Previous Menu. Type 5 to go back to the main
Diagnostics Menu.
1: Data Pattern
2: Data Size
3: Number of Test(s)
4: Test Increment(s)
5: On Error Policy
6: Enable/Disable Test Continuously
7: Enable/Disable Device(s) (allows you to select or deselect targets
and LUNs on which to run diagnostics)
8: Return to Previous Menu
Table 3-10 on page 3-81
Type the number associated with the parameter you want to change.
Type the number associated with the new parameter value.
Return to the previous menu.
Step 5.
Step
for a description of the parameters and their
4, the Diagnostic
SN0054614-00 K