Data Pattern Values - Qlogic SANsurfer FC/CNA HBA CLI User Manual

4–Non-Interactive Commands
Command Summary
The data pattern must be in a two-character hexadecimal pattern in the range
of 00–FF. The hexadecimal letters can be uppercase or lowercase. The default
pattern is random, for example:
# scli -kl(<hba instance> | <hba wwpn>) DP Random
To enter a customized value (in the range of 00–FF), type:
# scli -kl (<hba instance> | <hba wwpn>) DP <param value>
In addition to a hex pattern, you can enter a compliant random data pattern
(CRPAT), jitter tolerance pattern (CJTPAT), or supply noise test sequence
(CSPAT) for a loopback test. For example:
# scli -kl (<hba instance> | <hba wwpn>) DP CJTPAT
Table 4-7
00
55
5A
A5
AA
FF
Random
Customized (00–FF)
CRPAT
CJTPAT
CSPAT
Table Notes
Compliant random data pattern in a valid FC frame, as defined by the
a
ANSI document Methodologies for Jitter and Signal Quality
Specification - MJSQ Annex A - Test bit sequences.
Compliant jitter tolerance pattern in an FC frame, as defined by the ASIC
b
document listed above.
c Compliant supply noise test sequence in a valid FC frame, as defined by
the ASIC document listed above.
4-22
lists all valid data patterns:
Table 4-7. Data Pattern Values
Hexadecimal
a (loopback test only)
(loopback test only)
b
(loopback test only)
c
Binary
00000000
01010101
01011010
10100101
10101010
11111111
SN0054614-00 K