Options Shown By -Z; Command Summary - Qlogic SANsurfer FC/CNA HBA CLI User Manual

CLI
-g
-i
-l
-m
-p
-t

Command Summary

The command format for non-interactive mode is:
# scli -(Cmd) (<hba instance> | <hba wwpn>) (view | ?)
Where:
You can combine the commands -o, -s and -x with other options. However, they
must be at the beginning or at the end of the command line. Use these commands
as follows:
-o = Output the results to a file (see
For example:
# scli -l -o
-s = Silent mode (see
# scli -i all -s -o output.txt
-x = Outputs the results in XML format (see
on page
# scli -i all -x -o output.xml
SN0054614-00 K
Table 4-1. Options Shown by -z (Continued)
Description
Show system information
adapter
Show information
Show LUN list
Configure selective LUNs
Configure target persistent binding
Show target list
hba instance = Adapter port instance (use -g command to find)
hba wwpn = Adapter world wide port name
"-s (Silent Mode)" on page
4-48). For example:
4–Non-Interactive Commands
Command Summary
See User Guide Section
"-g (Display System Information)" on
page 4-18
"-i (Display HBA General Information
or VPD Information for One or All
HBAs)" on page 4-20
"-l (Display LUN Info)" on page 4-32
"-m (View, Enable, or Disable LUNs)"
on page 4-33
"-p (Display Persistent Target Binding
Info)" on page 4-38
"-t (Display Target Information)" on
page 4-45
"-o (Output to a File)" on page
4-45). For example:
"-x (Output in XML Format 1)"
4-37).
4-5