Qlogic SANsurfer FC/CNA HBA CLI User Manual page 314

D–Help Commands
Variable
<target wwpn>
<vport hex>
<vport wwpn>
Command
Line Action
— [ int ]
( <hba instance> | <hba wwpn> ) Flashes the adapter port LED to locate it in
–a
–a ( <hba instance> | <hba wwpn> )
( view | ?)
–b ( <all> | <hba instance> | <hba
wwpn> ) [ ( <–rg> <fw | boot|
all> ) ] <file name>
–b ( <hba instance> | <hba wwpn> )
save <file name>
( <hba instance> | <hba wwpn> ) Views the adapter parameters settings of
–c
–c [ <all> ]
D-2
Table D-1. Variables Used in Arguments (Continued)
World wide port name of a target device.
(xx-xx-xx-xx-xx-xx-xx-xx or xxxxxxxxxxxxxx).
World wide port name of the virtual port with the two hexadeci-
mal digits in byte three supplied by the user.
World wide port name of a virtual port.
Table D-2. Help Commands
Arguments
Description
Function
Starts interactive mode.
the host. This feature is not supported on
QLA22xx series adapters.
Shows the current LED state on an adapter
port.
Updates the adapter boot code from a file,
where:
<–rg> Specifies Option ROM region
update mode.
<all> Updates the flash from a full
image file (1MB image file).
<file name> Flash image file name.
Note: Region update is not available on
2Gb adapters. Flash update is not sup-
ported on 2Gb adapters in Macintosh. If
selected multiple adapters, only adapters
that are compatible with the provided flash
image will be updated.
Saves the adapter boot code to a file.
an adapter port.
Views the adapter parameters settings of
all adapters.
SN0054614-00 K