Configuring The Ethernet Port - Qlogic SANbox 5000 Series Interface Manual

4 – Network and Fabric Configuration

Configuring the Ethernet Port

4.3
Configuring the Ethernet Port
Configure the switch Ethernet port using the
an Admin session. The following example configures a new IP address, subnet
mask, and gateway address.
SANbox (admin) #> set setup system
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
EthNetworkDiscovery
EthNetworkAddress
EthNetworkMask
EthGatewayAddress
AdminTimeout
InactivityTimeout
LocalLogEnabled
RemoteLogEnabled
RemoteLogHostAddress
NTPClientEnabled
NTPServerAddress
EmbeddedGUIEnabled
Do you want to save and activate this system setup? (y/n): [n] y
4-4
(1=Static, 2=Bootp, 3=Dhcp, 4=Rarp)
(dot-notated IP Address)
(dot-notated IP Address)
(dot-notated IP Address)
(dec value 0-1440 minutes, 0=never)
(dec value 0-1440 minutes, 0=never)
(True / False)
(True / False)
(dot-notated IP Address)
(True / False)
(dot-notated IP Address)
(True / False)
Set Setup System command within
[Static
[10.0.0.1
[255.255.255.0] 255.0.0.0
[10.0.0.254
[30
[0
[True
[False
[10.0.0.254
[False
[10.0.0.254
[True
S
]
] 10.20.30.40
] 10.20.30.254
]
]
]
]
]
]
]
]
59183-01 A