Firmware Install Command - Qlogic SANbox 1400 Series Installation Manual

B – Command Line Interface

Firmware Install Command

Firmware Install Command
Downloads firmware from a remote host to the switch, installs the firmware, then
resets the switch to activate the firmware. This is disruptive to I/O traffic. To
perform a non-disruptive firmware installation, refer to the
page B-23.
The command prompts you for the following:
IP address of the remote host
An account name and password on the remote host
Pathname for the firmware image file
Authority
Admin
Syntax
firmware install
Examples
The following is an example of the Firmware Install command:
SANbox (admin) #> firmware install
Warning: Installing new firmware requires a switch reset.
Continuing with this action will terminate all management sessions,
including any Telnet sessions. When the firmware activation is complete,
you may log in to the switch again.
Do you want to continue? [y/n]: y
Press 'q' and the ENTER key to abort this command.
User Account
IP Address
Source Filename : 5.0.00.11_mpc
About to install image.
Connected to 10.20.33.130 (10.20.33.130).
220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.
331 Password required for johndoe.
Password: xxxxxxxxx
230 User johndoe logged in.
bin
200 Type set to I.
verbose
Verbose mode off.
This may take several seconds...
The switch will now reset.
Connection closed by foreign host.
B-18
: johndoe
: 10.20.33.130
Do you want to continue? [y/n] y
S
"Image Command" on
59225-00 B