Euphonix System 5 Operation Manual page 23

System 5 Digital Audio Mixing System Operation Manual
1.2.1 Overview of System Components
• Control Surface: Connects to the processing core via ethernet and the EuCon
Hub. Audio does not pass through the control surface.
• System Computer (SC261): Runs the eMix software application; all file man-
agement and system setup is done from this computer.
See Chapter 4: eMix Application.
• Interface Pilot Computer (PC253i): Supervises control functions for the
analog monitor controller, remote microphone preamps and transport control.
• Digital Processing Core (DF64): The DF64 is the digital audio processing
core for System 5. Digital audio is routed to and from the DF64 via MADI.
• Digital Pilot Computer (PC253d): Controls a DF64 digital processing core.
There is a Digital Pilot Computer for each DF64 (maximum of four).
• Studio Hub (SH612): One or two of these MADI routers are used to route
digital audio to and from the DF64 Digital Cores and the system I/O.
• System I/O: Digital and analog I/O units connect all of the devices in the studio
to the Studio Hub via MADI. See Console I/O on page 44.
23
Introduction