Connect And Monitor A Microphone; Cabling - Euphonix System 5 Operation Manual

System 5 Digital Audio Mixing System Operation Manual
Route to the Mix Bus
1. Press the Channel On switches for each CD channel.
2. Select the Mix button on channels 1 and 2.
3. Select the In key of the B Mix Bus; B defaults to 2-channel stereo.
4. In the Master Section, press the CR Source key to display the Mix busses in
the Panel Viewer. Select the B Source.
5. Move the channel 1 and 2 faders up.
6. Press both channel's Pan buttons and set to L and R, respectively.
7. In the Master Section, press the CR Output key to display the output formats
in the Panel Viewer and select Stereo.
8. Turn off the Cut button and use the Main Monitor knob in the Master Section
to adjust the control room monitor level.
3.2

Connect and Monitor a Microphone

Configure PatchNet
1. From the left side of PatchNet, select the Cabling tab.
2. Select MADI In Ports and select Hub 1-8 (any Hub can be selected).
3. Select MADI Out Ports and click in the MADI Out column next to Mic 1.
This tells the SH612 which AM713 is connected to the ML530.
4. Click Patch.
Figure 3-3 Cabling
29
Quickstart to Common Tasks