Center Section Select Panel - Euphonix System 5 Operation Manual

System 5 Digital Audio Mixing System Operation Manual
Spill Select
Spill Select allows Control Groups and Multi Format Masters to spill their slaves to a
defined area (see Spill Area on page 137 to learn how to spill the channels).
To specify a spill area:
1. From the Main Panel, press the Strips key.
2. In the Strip Config Panel Viewer, press the Spill Select key so it lights.
3. Press the Wave key for each strip that is to be part of the spill area.
Fader Unity
Fader Unity allows any fader(s) to be automatically set to unity gain (0 dB).
1. From the Main Panel, press the Strips key.
2. In the Strip Config Panel Viewer, press the Fader Unity key so it lights.
3. Press the Chan Select key for each channel to set unity gain.
The fader moves to 0 dB.
You can also press that channel's Channel Select key in the center section
Select Panel.
C5
N ON
solo
4. Deselect the Fader Unity key to turn off the Fader Unity function.
Fader Meters
The Fader Meters: parameter controls what the Strip fader's LEDs measure and can
be set using the keys that appear below and indented from the Fader Meters: key.
Off: Turns the Fader Meters off so nothing is displayed.
Meter: Displays the channel's input level on the right meter only. This is the PFL input
level, not the fader position.
Automation: Displays the underlying fader position while recording automation.
When the fader is punched out, the LEDs turn off. In Write Abs mode, the underlying
absolute level is displayed while recording new automation. Underlying levels are also
displayed when a fader is in Preview or Suspend modes while touching the fader. See
Automation Modes on page 176.
C6
C7
ON
solo
Figure 8-5 Center section Select Panel
C8
ON
solo
102
Channels and Strips
Channel
Select key