Setting Auto And Manual Glide Times - Euphonix System 5 Operation Manual

System 5 Digital Audio Mixing System Operation Manual
NOTE: Toggling the Glide settings is closely related to setting the automation mode.
Continuing to hold down the Wave key and repeatedly pressing the Select/
Punch key cycles through the automation modes. To toggle the Glide setting,
be sure to press the Select/Punch key once and then release both keys.
14.7.3

Setting Auto and Manual Glide Times

To set the Auto Glide time in the Automation Panel:
1. From the Main Panel, press the Automation button to display Automation
Panel Page 1.
2. Enter a timecode into the locate time display using the numeric keypad on the
center section (Figure 14-13).
The entire time must be entered, beginning with frames. When the first numeric
key is pressed, the display clears to enter the new value.
3. Press Store Locate and then the A/Glide key in Automation Panel Page 1 to
transfer the locate time to the A/Glide field.
Perform the same steps to set the M/Glide time but press the M/Glide key instead of
the A/Glide key step 3.
NOTE: If the A/Glide or M/Glide time is 0, a fader in that mode snaps abruptly to
match the underlying automation. This is the same behavior enabled by Snap
Mode (see Section 14.9.5 - Snap Mode).
187
Dynamic Automation