Time Display - Euphonix System 5 Operation Manual

System 5 Digital Audio Mixing System Operation Manual
followed by an insert of the same data at the time designated in the to field, which
appears to the right of the Move operation field.
When the Operation field is selected, typing m, i, c, or d on the keyboard selects Move,
Insert, Copy, or Delete, respectively.

Time Display

Click the button labeled FeetFrames or SMPTE (above the Start Time field) to toggle
between formats. Figure 14-15 shows the Conform screen with SMPTE times.
If Feet+Frames is selected:
• Entering a number into the Frames field larger than 16 will be converted auto-
matically into FeetFrames.
• Entering a single number, instead of two numbers separated by +, is assumed
to be Frames and is automatically converted to FeetFrames.
If SMPTE is selected:
• The number entered is parsed in two-digit intervals starting from the right. For
example, if 321215 is entered, the field is resolved to 00:32:12:15.
• Enter two-digit numbers separated by : and they will be parsed right to left. For
example, if 12:34:22 is entered, the field is resolved to 00:12:34:22.
• If a number greater than 59 is entered into the seconds or minutes field, it is
properly converted. For example, if 12:78:14 is entered, the field is resolved to
00:13:18:14.
• If a number greater than or equal to the FPS value stated in the upper right of
the Conform screen is entered into the Frames field, it is properly converted.
At 24 FPS, if 12:18:32 is entered, the field is resolved to 00:12:19:08.
• The maximum number that can appear in the hours field is 23.
Entering Notes
Click in the Start Time field to begin entering a note. Press the Enter or Tab keys on
the keyboard to move one field to the right. The fields do not have to be entered from
left to right and some fields are calculated automatically. For example, you can select an
Operation before setting time fields. If Start and End Times are entered, the Duration
field is calculated automatically. If Start Time and Duration fields are entered, End is
calculated automatically. The Total Change field is not set by the user but is calculated
automatically. It displays the net time change for all notes up to and including the
present one.
When all notes fields have been filled with valid entries, you must press the Add button,
which automatically enters the note in chronological order with respect to the other notes.
Pressing Enter or Tab with all fields filled with valid entries is equivalent to clicking the
Add button. When the number of notes exceeds the maximum screen size, a scroll bar
205
Dynamic Automation