Locate Key; Return Key; Title Start; Cue Points - Euphonix System 5 Operation Manual

System 5 Digital Audio Mixing System Operation Manual
12.2.4

Locate Key

Press the Loc key to locate the transport to the value in the Locate Time Register.
12.2.5

Return Key

Press the Return key to cycle the transport between the R/Start and R/End locations
(pre- or post-roll times are observed).
12.2.6

Title Start

12.2.7

Cue Points

Each Title can store up to 99 Cue points. To create a new Cue:
1. Press the Store Locate or Store Current key to use the Locate or Current
Time, respectively.
2. Press the Cue key (left of Store Current key).
The Cue is placed in the Cue list sorted by increasing timecode values.
Displaying and Using Cue Points
Press the Cue key by itself (lights to show it is active) to display the Cue list on the TFT
screen above the Master section. Use the SpinKnob to scroll through the list. The Current
Cue is highlighted in the list and its value displayed in the Locate Time Display. Press
the Loc key to locate to that Cue Point. Press the Cue key to deactivate it.
NOTE: If any of the Store Locate, Store Current, or Recall keys are flashing to indi-
cate they are waiting for a destination key to be pressed, pressing the Cue key
does not display the Cue list.
Next and Previous Cues
The following keys locate through the Cue List sequentially:
Locates to the previous Cue point.
Locates to the next Cue point.
Locates to the T/Start (Title Start) time set in the Locate Registers Panel
(Figure 12-4).
152
Machine Control