Patching Examples - Euphonix System 5 Operation Manual

System 5 Digital Audio Mixing System Operation Manual
For each ML530, PatchNet needs to know which MADI input the AM713 is connected
to so the mic preamp parameters appear on the corresponding input channel knobset.
For each Mic/Line Interface, note how it is connected. In the example that follows, the
MADI output from the Analog to MADI converters of two ML530 Mic/Line interfaces
have been connected to the inputs of Hub1-1 and Hub1-2.
1. Select Cabling in PatchNet.
2. Select the MADI Out Ports sub-category.
The list shows 7 Mic/Line Interfaces but only configure those wired to the Hub
(i.e., Mic1 and Mic2).
3. Click and drag through the cells to the right of Mic1 and Mic2.
The cells highlight green and the names appear in the Sources column of the
Selected: window below.
4. Select the MADI In Ports sub-category.
5. Click and drag through the cells to the right of the two Hub1 inputs (Hub1-1
and Hub1-2).
The cells highlight green and the names appear in the Destinations column of
the Selected: window below.
6. Click the Patch button to make the patch.
PatchNet now knows how the two mic/line interfaces are connected so the proper input
parameters appear at the top of the channels they are connected to.
Because Hub1-1 and Hub1-2 have been designated as MADI connections to the Mic/Line
interfaces, clicking on the Hub1-1 and Hub1-2 sub-categories in Device Outputs show
Device Patch in the first 24 cells and will not allow selection unless they are unpatched.
4.2.4

Patching Examples

Patch 12 mics into channels 25–36
Select the Sources
1. Click on Device Outputs from the four PatchNet categories.
2. Click on Mic-Line 1 from the sub-categories.
This displays all inputs in the center of the window from the first Mic-Line Inter-
face. In The Mic-Line Interface is connected as part of the initial studio setup.
46
eMix Application