Remote Interface Configuration; Lan Setting - Rigol DS6000 Series User Manual

RIGOL

Remote Interface Configuration

DS6000 can communicate with PC via LAN, USB and GPIB (with the USB to GPIB
interface converter of RIGOL) buses. Please refer to the introduction below to
configure the corresponding interface before using the remote interfaces.

LAN Setting

Press UTIL  IO Setting  LAN Set to open the LAN setting interface. You can
view the network connection status and configure the network parameters.
Network Status
Current IP
Config Type
MAC Address
VISA Address
IP Config Type
Status
Network Status
Connect the oscilloscope to your local area network using the network cable. The
LAN interface of the oscilloscope is on the rear panel. The oscilloscope will give
different prompts according to the current network connection status.
Net Config Success!

Acquire IP...

IP Conflict!

Unconnected!

DHCP Fail!

13-2
13 System Function Setting
DS6000 User's Guide