Set Horizontal And Vertical Motion Units - Epson TM-T88III Programming Manual

C O N F I D E N T I A L
GS P
[Name]

Set horizontal and vertical motion units

[Format] ASCII
Hex
Decimal
0 ≤ ≤ 255
[Range] x
0 ≤ ≤ 255
y
[Default] TM-J2000/J2100, TM-T88III,
TM-T90:
TM-L90:
[Printers not featuring this command] TM-P60, TM-U230, TM-U220,
[Description] Sets the horizontal and vertical motion units to approximately 25.4/
mm {1/
• When
• When
[Notes]
The horizontal direction is perpendicular to the paper feed direction and the vertical direction is the paper
feed direction.
The horizontal and vertical motion units indicate the minimum pitch used for calculating the values of
related commands (shown on the next screen).
In standard mode, the following commands use
• Commands using
• Commands using
In page mode, the following commands use
lower right of the print area using ESC T.
• Commands using
• Commands using
Paper roll Miscellaneous commands
Miscellaneous commands
x y
GS P
x y
1D 50
x y
29 80
x y
= 180, = 360 [Other than Japanese model]
x y
= 203, = 406 [Japanese model]
x y
= 203, = 406
y
"}, respectively.
x
= 0, the default value of the horizontal motion unit is used.
y
= 0, the default value of the vertical motion unit is used.
x
: ESC SP, ESC $, ESC \, GS L, and GS W
y : ESC 3, ESC J, ESC K, GS A and GS V
x : ESC SP, ESC $, ESC W, ESC \ and FS S.
y : ESC 3, ESC J, ESC K, ESC W, GS $, GS A, GS V, and GS \
x y
TM-L60II: = 180, = 360
TM-U210,
x y
or .
x or y , when the starting position is set to the upper left or
GS P
TM-U300A/B
x x
mm {1/ "} and approximately 25.4/
Ver. 10.01 p. 470
S
ETTING COMMAND
y